Wanshuangyu

Customizing winding film: What should we pay attention to when using winding film?


缠绕膜

 

Winding film customization: the use of attention to the elements

1. Many customers think that the winding film must be relatively easy to break, especially when it is pulled hard, so when we pack it, the protection of the edge is very important, especially no burr phenomenon, to ensure the quality of the product in packaging.

2, if the cutting is not smooth, it can not be shipped directly, must ensure that the packaging is neat enough, and the cutting of the side material should also be neat, can not appear any adverse phenomenon.

3, winding film customization: try to reduce the wrinkling phenomenon at both ends, and the red line in the middle can not be pressed, which will seriously affect the overall packaging beauty.

4, in the packaging, can not appear different length phenomenon, and on both sides of the reserved space of about 1㎝, the packaging items are aligned.

5. Clean the winding film on the tip to ensure that there are no black impurities, and no burnt plastic can be added to it. If it can be seen directly by the naked eye, it must be removed immediately.

Winding film customized: and it can be used in the absence of heating, in different directions of stretching, mainly according to its own viscosity, so more or used in the transportation of packaging, or in the tray, it can also ensure that the packaging of items, in a long time to maintain its tension, will not appear any loose phenomenon.

What causes the forming effect of stretch film to be bad?

With the application of stretch film more and more widely, we can see the production of stretch film manufacturers are more and more, in many production of stretch film manufacturers, there is no lack of some small manufacturers Bingzhe the purpose of making money quickly to produce some substandard stretch film, so many people have found that they buy these manufacturers of stretch film products molding effect is not ideal, Even very affect our use, so in the end what is the cause of the tensile film molding effect is not good?